Wurth Gravel Throw & Underbody Protection - Grey (500ml-1L)

Rubber-based coating compound containing solvents, can be painted over

• Excellent adhesion, quick skin formation
• Scratch-resistant
• Can be painted over with many commercially available, solvent-based and water-based one-component and two-component top coat paints
• Suitable for oven drying briefly at 40°C to 60°C
• Highly sandable once fully dry

Tip for pros

• Various structures can be sprayed by changing the distance or pressure
• The colour will become darker by staining it with clear varnish

Notice

• Do not spray on joints, engines, gears and brake systems. After use, turn the can upside down and spray until the valve is empty. Do not dilute, or mix with water or paint. The product can be painted within 24 hours. It can then only be painted once it has been sanded and cleaned.

Technical information

Rubber-based coating compound containing solvents, can be painted over

• Chemical basis: Natural rubber
• Max. processing temperature: 25 °C
• Min./max. spraying distance: 20-30 cm
• Conditions for drying time: at 20°C and 65% relative humidity
• Min./max. temperature resistance: -40 to 90 °C

Application area

• For repairing and restoring the original structure and for protecting against stone chips and corrosion in all visible areas, e.g. front and rear aprons, side members, bumpers and chassis on cars, trucks and buses. Ideally suited for use as an anti-humming compound for wheel wells and chassis.

Instructions

• Shake well before use. The surface must be clean, dry and free from rust and dust. Spray a very thin first coat for improved adhesion and let it flash off for approx. 3 minutes. Then apply the next coat. Allow each intermediate coat to flash off. Operating pressure: 2-4 bar. Optimum spraying distance: 30 cm. The best spraying results are achieved at a processing temperature of 15-25°C.